微波瑞利散射法测定空气电火花激波等离子体射流的时变电子密度

大气压空气电火花激波等离子体射流的电子密度在亚微秒时间尺度上瞬变,其电子密度的测定很难.基于微波瑞利散射原理,本文测量了空气电火花冲击波流注放电等离子体射流的时变电子密度.实验结果表明:测量系统的标定参数A为1.04 × 105 V·Ω·m–2;空气流注放电等离子体射流的电子密度与等离子体射流的半径和长度有关,结合高速放电影像展示的等离子体射流的等效半径和等效长度,测定的电子密度在1020 m–3的量级,且随时间先快速增长至峰值再成指数衰减.此外,本文还探讨了等离子体射流的不同等效尺度对测定结果的影响;分析结果表明,采用时变等效半径和时变等效长度的计算结果最有效,且第1个快速波峰是由光电离的电离波导致的.     

3d过渡金属掺杂M_2@Si_(20)(M=Sc-Zn)团簇的密度泛函理论研究

利用密度泛函理论(DFT)研究3d过渡金属掺杂硅团簇的几何结构和稳定性,计算了绝热电子亲和能和垂直电离能,内嵌双金属间距,自旋磁矩等.结果表明内嵌的Sc、Ti、V、Mn金属二聚体和十二面体硅笼构成了稳定的富勒烯结构,随着d电子数目的增加其内嵌的富勒烯构型有部分畸变,总体而言Si_(20)团簇掺杂双金属后稳定性得到了提高.     

Cascaded electron transition in CuWO_4/CdS/CDs heterostructure accelerating charge separation towards enhanced photocatalytic activity

CuWO_4,as an n-type oxide semiconductor with a bandgap of 2.2 eV,has stimulated enormous interest as a potential broad-spectrum-active photocatalyst for environmental pollution remediations.However,rapid charge recombination greatly hinders its practical applications.Herein,we present a cascaded electron transition pathway in a ternary heterostructure consisting of CdS quantum dots,carbon dots(CDs) and CuWO_4 hollow spheres,which proves to greatly facilitate the photogenerated electron-hole separation,and eventually boosts the degradation efficiency of phenol and congo red by 100% and 46%compared to bare CuWO_4.The enhanced performance of the CuWO_4/CdS/CDs heterostructure mainly originates from the unidirectional electron migration from CdS to CuWO_4 and then to the organics through CDs.This work elucidates the electron transfer kinetics in multi-phase system and provides a new design paradigm for optimizing the properties of CuWO_4 based photocatalysts.     

有耗介质层上多导体传输线的电磁耦合时域分析方法

目前,针对空间电磁场作用有耗介质层上传输线的电磁耦合,仍缺乏有效的数值分析方法.因此,本文提出一种高效的时域混合算法,很好地解决了有耗介质层上传输线电磁耦合建模难的问题.首先,对经典传输线方程进行改进,推导了适用于有耗介质层上多导体传输线电磁耦合分析的修正传输线方程.然后,结合时域有限差分方法和相应插值技术,求解修正传输线方程,获得多导线及其端接负载上的电压和电流响应,并实现空间电磁场辐射与多导线瞬态响应的同步计算.最后,通过相应计算实例的数值模拟,与CST软件的仿真结果进行对比,验证了时域混合算法的正确性和高效性.     

周期性管柱信道的声波通信技术研究综述

井下声波通信技术利用周期性管柱信道实时传输声波数据，相比于其他通信方式，具有适应性好、复杂度低、传输效率高等优点，在随钻地质导向、油水井监测等方面有广阔的应用前景，是发展智能油田的关键技术之一。本文主要综述上世纪90年代以来关于信道物理模型、信道容量、声信号调制与接收方法等关键问题的研究历程，并对通信系统的设计要点与国内外相关产品的现场应用进行梳理，为后续的技术改进提供依据。     

Photo-recycling the Sacrificial Electron Donor: Towards Sustainable Hydrogen Evolution in a Biphasic System

H₂ may be evolved biphasically using a polarised liquid|liquid interface, acting as a “proton pump”, in combination with organic soluble metallocenes as electron donors. Sustainable H₂ production requires methodologies to recycle the oxidised donor. Herein, the photo-recycling of decamethylferrocenium cations (DcMFc⁺) using aqueous core-shell semiconductor CdSe@CdS nanoparticles is presented. Negative polarisation of the liquid|liquid interface is required to extract DcMFc⁺ to the aqueous phase. This facilitates the efficient capture of electrons by DcMFc⁺ on the surface of the photo-excited CdSe@CdS nanoparticles, with hydrophobic DcMFc subsequently partitioning back to the organic phase and resetting the system. TiO₂ (P25) and CdSe semiconductor nanoparticles failed to recycle DcMFc⁺ due to their lower conduction band energy levels. During photo-recycling, CdS (on CdSe) may be self-oxidised and photo-corrode, instead of water acting as the hole scavenger.     

传输线方程的高精度龙格−库塔数值求解方法

提出了一种求解传输线方程的高精度龙格-库塔(RK)方法。此方法在空间上采取高阶泰勒展开,提高了对空间微分的近似精度,减少了数值色散所带来的误差。与传统的时域有限差分法(FDTD)方法相比,在每波长采样数相同时,RK方法的计算精度更高。同时,根据Taylor模型,对外界平面波激励源进行离散,成功利用RK方法对外部场激励传输线进行求解,扩大了龙格-库塔方法在求解传输线方程时的应用范围。通过编程对平面波辐照下无限大地平面上的单导体与双导体的算例分别应用FDTD方法与RK方法进行了计算,验证了RK方法的正确性。结果表明同等计算条件下RK方法的计算精度更高。     

Unusual Bonding and Properties in Main Group Element Chemistry: Rational Synthesis,Characterization, and Experimental Electron Density Determination of Mixed‐Valent Tetraphosphetes

Five dispirocyclic λ³,λ⁵‐tetraphosphetes [{R₂Si(NR¹)(NR²)P₂}₂] (R¹ = R² and R¹ ≠ R²) are easily prepared in almost quantitative yields via photolysis of the respective bis(trimethylsilyl)phosphanyldiazaphosphasiletidines with intense visible light. These deep‐yellow low‐coordinate phosphorus compounds can be considered as the first higher congeners of the well‐known cyclodiphosphazenes. The tetraphosphetes are remarkably stable in air and show unexpected molecular properties related to the unique bonding situation of the central four‐π‐electron four‐membered phosphorus ring. The extent of rhombic distortion of the central P₄ ring is remarkable due to an unusually acute angle at the σ²‐phosphorus atoms. All of the P?P bonds are approximately equal in length. The distances are in the middle of the range given by phosphorus single and double bonds. The anisotropic absorption of visible light that can easily be observed in the case of the yellow/colorless dichroic crystals of [{Me₂Si(NtBu)(NtBu)P₂}₂] and the exceptional ³¹P NMR chemical shift of the σ²‐phosphorus atoms are the most remarkable features of the λ³,λ⁵‐tetraphosphetes. In the case of [{Me₂Si(NtBu)(NtBu)P₂}₂], the Hansen–Coppens multipole model is applied to extract the electron density from high‐resolution X‐ray diffraction data obtained at 100 K. Static deformation density and topological analysis reveal a unique bonding situation in the central unsaturated P₄ fragment characterized by polar σ‐bonding, pronounced out‐of‐ring non‐bonding lone pair density on the σ²‐phosphorus atoms, and an additional non‐classical three‐center back‐bonding contribution.     

Role of the Bridge in Photoinduced Electron Transfer in Porphyrin–Fullerene Dyads

The role of π‐conjugated molecular bridges in through‐space and through‐bond electron transfer is studied by comparing two porphyrin–fullerene donor–acceptor (D–A) dyads. One dyad, ZnP–Ph–C₆₀ (ZnP=zinc porphyrin), incorporates a phenyl bridge between D and A and behaves very similarly to analogous dyads studied previously. The second dyad, ZnP–EDOTV–C₆₀, introduces an additional 3,4‐ethylenedioxythienylvinylene (EDOTV) unit into the conjugated bridge, which increases the distance between D and A, but, at the same time, provides increased electronic communication between them. Two essential outcomes that result from the introduction of the EDOTV unit in the bridge are as follows: 1) faster charge recombination, which indicates enhanced electronic coupling between the charge‐separated and ground electronic states; and 2) the disappearance of the intramolecular exciplex, which mediates photoinduced charge separation in the ZnP–Ph–C₆₀ dyad. The latter can be interpreted as a gradual decrease in electronic coupling between locally excited singlet states of D and A when introducing the EDOTV unit into the D–A bridge.     

Fabrication and microstructural characterization of functionally graded porous acrylonitrile butadiene styrene and the effect of cellular morphology on creep behavior

The ability to control material properties in space and time for functionally graded viscoelastic materials makes them an asset where they can be adapted to different design requirements. The continuous microstructure makes them advantageous over conventional composite materials. Functionally graded porous structures have the added advantage over conventional functionally graded materials of offering a significant weight reduction compared to a minor drop in strength. Functionally graded porous structures of acrylonitrile butadiene styrene (ABS) had been fabricated with a solid‐state constrained foaming process. Correlating the microstructure to material properties requires a deterministic analysis of the cellular structure. This is accomplished by analyzing the scanning electron microscopy images with a locally adaptive image threshold technique based on variational energy minimization. This characterization technique of the cellular morphology is analyst independent and works very well for porous structures. Inferences are drawn from the effect of processing on microstructure and then correlated to creep strain and creep compliance. Creep is strongly correlated to porosity and pore sizes but more associated to the size than to porosity. The results show the potential of controlling the cellular morphology and hence tailoring creep strain/compliance of ABS to some desired values. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 795–803